Sloping Floor Flange (30-45 degrees) for 42mm Galv Pipe D1VD02 PLEASE NOTE : It is

PLEASE NOTE : It is supplied as a 1-piece unit designed to slip over a 90 x 90mm post during installation

Greenhouses

Please note that no fixing screws are provided

often used to join intermediate uprights to top rails and middle rails to end uprights

Sloping Floor Flange (30-45 degrees) for 42mm Galv Pipe D1VD02 PLEASE NOTE : It isWhere would you normally use this galvanised pipe fitting? The 251 Slope Base Flange (30 degree to 45 degree) is a base flange for sloping sites, adjustable from 30 degree to 45 degree. As the fixing holes in the base cannot be fixed in line with the applied load, it is only intended for light loads or structures which are sufficiently supported by virtue of their design. Where a greater load is required, type 132 is normally used, with the upright