90 degree Elbow for 60mm Galvanised Pipe Roof Finial Where would you normally use

Where would you normally use a wooden table leg

Greenhouses

Plantation grown Radiata Pine that has been H3 treated (suitable for above ground use)

but it is actually more of a satin (brushed) finish

90 degree Elbow for 60mm Galvanised Pipe Roof Finial Where would you normally useWhere would you normally use this galvanised pipe fitting? The 125 is a 90 degree angle joint, often used where top rail meets end upright on level sites. What size pipe does it fit to? This fitting will work with galvanised pipe (tube) of an outside diameter of approximately 60mm. What is it made out of? All of the pipe fittings are made from malleable iron and then hot dipped galvanised to exceed the requirements of AS NZS 4680: 2006, giving a